Body Side Molding

Fine Body Side Molding Suggestions

Fine Body Side Molding Suggestions

Are you looking for body side molding?


Here's Body Side Molding Selections:

3M Company 1/2X5 Molding Tape 03609Na Automotive T...

Customer Review:
Click Here for More Info


$5.79

 

Auto-Tech Plastics BCG-008 Black with Chrome Inser...

Customer Review:
Click Here for More Info




 

Astro Pneumatic 4505 5-Piece Fastener and Molding ...

Customer Review:
Click Here for More Info


$13.28

 

Case-Mate iPhone 4 Pop! Case - Pink & Grey...

Customer Review:
Click Here for More Info




 

CRL 1987+ Toyota Camry Backglass Molding Clip (Upp...

Customer Review:
Click Here for More Info




 



korek api
 
Today's Discussion

How do i remove the body side molding off a 2006 dodge charger without damaging the paint/body?
I want to give my charger a cleaner look by removing the body side molding, but i don't no if it's a job i can do myself or if i have to take it to a bodyshop. If anybody has done this before, please give me some advice.

Reply
Quiet.Buck
1. you need to check w/ the parts department at a Dodge dealer. see this trim piece first hand new. Is it plastic bolted on or just 2 side taped. 2. if it has plastic bolts.. you are out of luck. cause that means under the trim is holes in the door skins. to remove the moldings will leave holes. 3. if just 2 sided taped, can be removed a few ways a. using a heat gun, warm the trim up and slide a plastic putty knife under the edge and start pulling. Take your time. Each side should take at least 10 minutes this way. b. using some dental floss or fishing line, slide this behind the trim and move the line back and forth and use it like a saw and cut the 2 sided tape in half. this works but leaves such a mess of tape residue that you sit for the next few hours picking it all off. c. whichever way you go... once its off. lacquer thinner will remove the glue/tape reside. otherwise it will need waxed up where the tape was.




Related Images
                

Related News
Tue, 22 May 2012 18:07:39 GMT
FIRST LOOK! 2013 KAWASAKI KX250F MOTOCROSS BIKE: LOTS OF CHANGES, IMPROVED ...
Motocross Action Magazine
Formed using a double-injection molding process, the shrouds offer a slim design. New smaller side number plates also contribute to the slim package. Right side panel has an added passageway to help cool the silencer. Flatter design of the seat and ...

and more »
Mon, 07 May 2012 21:28:42 GMT
NPE2012 hot runner rundown: The age of hot runner systems is upon us
Plastics Today
The tip is inserted directly from the parting line on the side of the molding surface to ensure a high degree of service friendliness and ease of processing without a cold slug. This linear arrangement in combination with the slim design of the hot ...